2003 Bandit Beast 3680 350HP Cummins - Rebuilt engine, injectors, PTO and Twin Disc clutch - New radiator/tanks - New hydraulic motors on outfeed belt and discharge screws - New Vulcanized outfeed belt - Has remote control but solenoid valves have been disconnected. This Beast of a grinder ran daily for 2+ years for us and was a champion, did whole log chipping and chip regrind no problem. Could use some patching in the grinding chamber and discharge belt frame, but is ready to run as-is. $75,000

Pneumafil Baghouse - $125k - Comes with 200HP motor - Model 13.5-460-10 - 13.5' diameter, 460 fabric socks, CFM with 5-1 A/C - 28,500, 10-1 A/C - 57,500

2017 Precision Husky 10x20 3-deck Chip Screener - $80k Model 10x20 Serial S 2679 Bearings and drive motor all sound good, great condition

2017 Precision Husky Disc Screener - $30k Model PDS648 - 6 roll, 48" wide Serial PDS 118

2017 Precision Husky Drop Feed Rechipper - $60k Model 5860 15 Serial C 3733 6 knife Comes with 150HP motor

2018 Schutte Buffalo 1590 Hammermill - $75k Comes with 250HP motor Air Plenum discharge Comes with new hammer sets (2), pins, screens, wear liners