Fully functional Spare pumps, motors, hoses, main cable drum and shaft (approx. $5,000 worth of parts!!) Comparable to a 215 Tyrone Berry Oil heater and safety switch in tank

Shurman Double Arbor Gang Saw 12" Capacity Thin Kerf Babbit Grinder

(9) Sets of Six Dry Kiln Controls

Only 6-8 fans available Building not included

Good Condition Ready to Load

Good Condition Used Regularly

Simonds RMO 942 Auto Leveler 480V Excellent Condition

Morgan Unscrambler - Hydraulic Drive Cant Chop Saw - 20" Blades, 6"x9" Capacity, 10 HP Motor, Pneumatic Cycle, Fixed Stop Smith Resaw - 15 HP Motor, 13'2" x 1.25" Bands, variable feed speed - MISSING drive motor and gearbox for the feed belt. Includes: Powered infeed conveyor leading to the resaw with VFD. Machine required 480v/3Ph for saws, 240v/1Ph for VFD units and controls. All control contacts are contained in a single box. All wires were labeled upon removal.

Soderhamn 48" Chipper M671 Diesel Engine Mounted on trailer

PalletPal Spring Lift Table Specifications Load capacity 400 to 4500 lbs., depending on springs Load size .......50" wide x 50" long x 72" high (max.) Length 45 1/4 inches Width (base frame) 36 3/4 inches Compressed height 9 1/2 inches Extended height 27 3/4 inches Rotating ring, outside diameter 43 5/8 inches Rotating ring, inside diameter 40 5/8 inches Adjustment for sloping floors Can adjust for floor slope up to 1:25 using optional adjustable feet 4 Available

4000# capacity 96” x 64” table size raised height 38-1/2" Lowered height 14-1/2" pneunatic operation Rotatable table 360 degrees safety skirts

20’ speed cut system. Was pulled out of production September 26th.

Sprout- Waldron shaker screener, was running when pulled out of production.

Stenner 36" Bandsaw, older unit but was running when pulled out of production.

15 HP Dust System

Stromab Stromab TR350 Up Cut Saw 4 HP Motor (230v/3ph) Variable Feed Speed This was a demo machine. Ready to ship!

Stromab TR450 Upcut Saw Demo unit - very low usage!

10 HP 575 volt unit. Has between 25-27 CFM. RPM: 1745

CMS represents Big on Dry (BOD) Thermo Wood Kilns in the USA. This system is another on elf our customers in the USA who is producing mostly poplar and oak decking. Big on Dry has improved the Thermo-Modification process with their THERMOWOOD (THW) line and provides complete "turn key" systems. The PLC control systems allow programming for a wide variety off wood applications. This allows the same systems to work with very delicate wood that is hard to treat to thicker wood that will be used for outdoor products. The THW system can also be used as a conventional kiln with steam. Basic systems include: - Kiln completely built with stainless steel and aluminum - Initial humidy of 10-15% is reduced to 5-6% - Loading options: Side or Trolley - Heating options: Gas or Wood Burner - Humidification: Combined Spraying System

Timber Treatment Solutions (TTS) manufacturers specialized timber treatment and preservation equipment. These systems are engineered to our specific customers specifications and applications. The TTS systems are turn key with installation and service available. - High Pressure Impregnation Plants - Low Pressure Impregnation Plants - Automated Material Handling Systems - Dip Tanks - Automation available - Hot Oil Treatment - Treatment Tunnels for individual lieces - Timber Incising Machines - Automation and control systems